Employment Opportunity / RFQ (Request for Quote).What am I missing? Any tips or ideas on places to start searching for the problem? I just exported the nc file from easel and opend it up in the grbl control, sent it to the machine and it tried cutting through my material mounting plate and wasn’t going to stop until I told it so?, leading me to believe it’s not me stressing the machine while carving. What little carving it’s done looks great and I don’t feel the machine is stressed while cutting. I tried using super slow feed rates and plunge rates, 5mm a min on both and nothing seems to change. The same carve on soft wood goes great and no problems. As soon as I plug it all back in, everything works as it should until I start carving again. Once everything is set up and I start carving, everything starts well and then 1-20 seconds into the carvel, easel says it’s all done and the 3018 stops where it’s at, spindle is spinning and the only way to stop it is to disconnect the usb and shut the 3018 off. It may help to point your computers camera directly at the. I use easel to write my G Code set everything up, then you can go to the advanced menu and export it and run it in a software that your machine will work with. I’m trying out some very simple stock shapes on easel just to get cut settings and feed rates dialed. I played around with Easel and it seemed very easy but when I went to cut, it said it couldnt find my machine. The problem I’m having is with some 1 and 2mm carbon fiber plates. I always wanted to get into cnc since I was a kid and finally the 3018 has brought that to me at a super reasonable cost of entry.
0 kommentar(er)
